How to replace the spark plugs and ignition coils for Toyota Corolla. I’m replacing the spark plugs and ignition coils on my 2010 Toyota Corolla but this is also for the 2009-2013 but also for Toyota, Lexus, Scion, and Pontiac cars with the 1.8L engine. Below are a list of parts and tools I used for this DIY project but also some others I’ve done as well.
To see some additional content, check out my instagram and TikTok.
• Instagram: @mtparadise_
• TikTok: @mtparadise
*Check out my official merch store and support my channel. Shop MT Paradise (link below).
Toyota Corolla Amazon Parts 👇
– Spark Plug & Ignition Coil Set
– Alternator Replacement
– Goodyear Serpentine Belt
– Denso O2 Sensor Downstream
– Denso O2 Sensor Upstream
– Starter Motor for Toyota Corolla
– Aluminum Coolant Pipe Bracket
– Coolant for Toyota Red/Pink
– Toyota Corolla Trunk Latch
– 10.5in Rear View Mirror
– Fuel Door Spring For Toyota Corolla
– Spark Plugs and Ignition Coil bundle for Toyota Corolla
– Mass Air Flow Sensor
TO PICK UP THE TOOLS AND EQUIPMENT I USED, SEE BELOW. 👇
– BlueDriver Bluetooth OBD2 Diagnostic Scan Tool and for iPhone and Android
– Spark Plug Sockets
– Pry Bar Set
– Torque Wrench with case
– Quick Jack 5000lb Portable Car Lift
– Quick Jack 7,000lbs Portable Car Lift
– O2 Sensor Removal Tool Set
– Thin Wall O2 Sensor Socket
– Pro-Lift Mechanic Plastic Creeper 36 Inch
– Socket Set 69 Piece
– Socket Set of Extentions, Adaptors, and Flex Joints
– Pry tools for Clips and Tabs
– Torques Screw Driver Set
#howto #howtofix #diy #diyprojects #cars #mechanic #replacement #toyota #corolla #automotive
I have the same year and started with a P0301 code, I did replaced the ignition coils, cleaned the throttle body and cleaned the air cold intake filter, mine it’s a K & N, I still with the rough iddle, I was wondering if it’s the spark plugs or the fuel injectors? any recommendations?
Thanks Bro!
I had a error code that says cylinder two is a misfire. I have noticed it running a little bit rough over the last few weeks and today I believe that cylinder gave up the ghost! Thanks to your video. I will attempt to do this work myself to save myself several hundred dollars of labor at the mechanic shop! Thank you so much for your video and clear instructions.
Dont forget to reconnect your battery at the end! 7:24 I suggest to add a popup note on your video
why you linking a 16mm when yo uuse a 14mm?